Kenmore Microwaves Turntable Not Spinning: How to Fix It Yourself
When the turntable in your Kenmore microwave stops spinning, the cause is usually a broken coupler or a burned-out turntable motor. Both are inexpensive parts. Food still cooks without the turntable, but it won't heat evenly.
Tools Needed
Watch the Video
Video guide coming soon! Subscribe to our YouTube channel for repair walkthroughs.
Subscribe on YouTube⚠️ Safety First
- Always unplug the appliance from the wall before starting any repair work.
- Microwaves contain a high-voltage capacitor that can hold a lethal charge even when unplugged. Do not open the microwave cabinet unless you are experienced with appliance repair. The steps below focus on safe, external fixes.
Before You Start
Parts You May Need
Step-by-Step Repair
- Step 1 of 51
Check the turntable support
Remove the glass turntable plate from your Kenmore microwave. Check the small roller ring guide underneath — it should roll smoothly. Clean it and the floor of the microwave. Food buildup can jam the rollers.
Photo: Check the turntable support - Step 2 of 52
Inspect the coupler
The coupler is the three-pronged plastic piece that connects the turntable to the motor shaft. Check if it is cracked or worn. Also check that the glass plate sits properly on the coupler. A replacement coupler costs about $3-$8.
Photo: Inspect the coupler - Step 3 of 53
Check the motor
The turntable motor is underneath the microwave floor. Unplug the microwave. If the coupler spins but the plate doesn't, the coupler is stripped. If the coupler doesn't spin at all, the motor may be burned out. On many Kenmore models, the motor is accessible from the bottom panel.
Photo: Check the motor - Step 4 of 54
Test the motor
If you have a multimeter, unplug the microwave and test the motor terminals for continuity. No continuity means the motor is dead and needs replacing. A turntable motor costs about $10-$25 for most Kenmore microwaves.
Photo: Test the motor - Step 5 of 55
Replace and test
Install the new coupler or motor (usually 2-3 screws), reconnect the wires, put the plate back on, and plug the microwave in. Heat a cup of water for 30 seconds — the turntable should spin smoothly.
Photo: Replace and test
You might also like:
If That Didn't Work
- A faulty control board on your Kenmore microwave could be the root cause, though this is less common.
- Wiring issues between components — loose or corroded connections — can cause intermittent problems.
When to Call a Professional
If the steps above don't fix your Kenmore microwave, a professional repair technician can diagnose the issue quickly. Most repairs cost $100-$250 including parts and labor. If your microwave is older than 8-10 years, compare the repair estimate to the cost of a new one.
Related Guides
More Kenmore Microwaves Guides
Turntable Not Spinning Guides for Other Brands
Disclaimer: This guide is for informational and educational purposes only and does not constitute professional repair advice. All repairs are performed at your own risk. RepairItFree.com is not liable for any personal injury, property damage, device damage, voided warranties, or other losses resulting from the use of this information.
If you are unsure about any step — especially anything involving electricity, gas, water, or refrigerant — stop and consult a qualified professional. Your safety is more important than saving money.
See our full Terms of Service for complete legal details.